Ball mill is turned by the bearing in the cement production line, when the bearing is in operation; the friction is inevitable, which will reduce the service life of bearing. In order to extend the life of ball mill bearing, it is necessary for us to take appropriate measures during the production line.

1. The large bearing group should match with larger diameter shaft group or the housing bore, while the one of smaller size should match the bearing of smaller diameter. In the process operation, the bearing with larger gap should match the relatively tight collocation and the bearing with small gap should choose the loose collocation. In this way, it can realize the most appropriate application of the bearing in the installation of the ball mill, not too tight or too loose.

2. During the production of the ball mill, the journal or the coaxial degree of the housing bore and the vertical degree of the supporting end surface need to be protected, this is helpful to avoid excessive load. If circumstances permit, it should make the other mechanical parts which inside the ball mill far from bearing, at the same time ensure the normal operation of the shaft and the rotating parts.

As the grinding equipment manufacturer, great wall corporation provide high-quality ball mill. In the past 60 years, we also win the trust from our customer. If you have any questions about the ball mill or spare parts, please contact us without hesitate.